Dynaudio Connect Speaker driver for Windows 7 - Dynaudio Connect Speaker driver from Dynaudio for

Dynaudio Connect Speaker 1.04

Dynaudio Connect Speaker driver from Dynaudio for OS Independent

Dynaudio Connect Speaker driver from Dynaudio for OS Independent

Publisher review for Dynaudio Connect Speaker 1.04:

Before install Dynaudio Connect Speaker 1.04you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Dynaudio Connect Speaker . We recommend to always use most recent version of a driver.

Fixes:- This release includes bugfixes related to DLNA
Dynaudio Focus XD firmware update instructions1. Unzip the downloaded Zip file
2. Copy the *.bin firmware file onto the USB stick.
3. Switch OFF the loudspeaker with the rear panel switch.
4. Insert the USB stick into the USB port at the rear panel labeled Service.
5. Switch ON the loudspeaker with the rear panel switch.
6. The loudspeaker will automatically upload the firmware from the USB stick.
7. Important: After this, allow the speaker to install the full update during the next 1-3 minutes. DO NOT POWER OFF THE SPEAKERS.
8. During this update the white LED’s will blink slowly, filling up from the bottom.
9. After installation, the speaker will return to standby.
10. Firmware update procedure is now finished, and the USB stick can be removed.
Please note: The firmware update must be performed on both speakers! 11. After firmware update is completed, disconnect and reconnect power to the speaker. The speaker will search the environment for about 40 seconds, during which the LED is blinking red.
Please Note: Step 11 must be repeated if you change the transmission setting or Channel ID on a Dynaudio Connect.

Operating system:
OS Independent